|
Product Details:
|
| Usage: | High Voltage Tracking Index Tester | Power: | AC 220V/50HZ |
|---|---|---|---|
| Standards: | IEC60587-2007, ASTM D2303 | Drop Height: | 30mm ~ 40mm Adjustable |
| Test Voltage: | 100~6000V Adjustable | Warranty: | 12 Months |
| High Light: | High Voltage Tracking Index Tester,ASTM D2303 Plastic Testing Equipment,High Voltage Tracking Plastic Testing Equipment |
||
High polymer high voltage leakage tracking, resistance to tracking:
Silicone products have good electrical insulation properties. Their dielectric loss, voltage resistance, arc resistance, corona resistance, volume resistivity and surface resistivity are among the best in insulating materials, and their electrical properties are affected by temperature and frequency. The impact is very small. Therefore, they are a kind of stable electrical insulating materials, which are widely used in the electronics and electrical industries.
In addition to excellent heat resistance, silicone also has excellent water repellency, which is a guarantee for high reliability of electrical equipment used in wet conditions. The high-voltage tracking tester produced by Dongguan Daxian Instrument is a testing equipment developed and designed for the electrical insulation performance, tracking resistance and corrosion resistance of silicone products.
| The constant tracking voltage method | the constant tracking voltage is the highest voltage at which 5 samples are not damaged after 6 hours |
| The step-by-step voltage tracking method | the step-by-step tracking voltage is the highest voltage that the five samples are not damaged after being subjected to Ih. |
Instructions for use:
Note: Use a new filter paper liner for each test.
First, pour the contaminated liquid into the filter paper liner to make the filter paper fully wet. Adjust the flow rate of the contaminated liquid and correct the flow rate as specified in Table 1. Observe the flow for at least 10 minutes to ensure that the contaminated liquid flows stably on the surface of the sample between the two electrodes. The contaminated liquid should flow from the shaft hole of the upper electrode and not overflow from the side or top of the filter paper.
Preparation of the sample:
Contact Person: Sophia Su
Tel: +86-13266221899
